Correct Yamaha TTR 125 Tire Pressure for Safety

The Yamaha TTR 125 is a popular choice among dirt bike enthusiasts, known for its reliability and performance. Proper tire pressure is crucial for optimal handling, safety, and tire longevity. Understanding the recommended tire pressure for your specific model can enhance your riding experience and prevent unnecessary wear on your tires.

Yamaha TTR 125 Tire Pressure

Tire Pressure Table for Different Trim/Engine

Yamaha TTR 125 Tire Pressure Sensor Reset

When the tire pressure monitoring system (TPMS) light on your Yamaha TTR 125 starts flashing, it indicates that the tire pressure sensor needs to be reset. This could happen after adjusting tire pressures or changing tires. Resetting the sensor ensures that your bike accurately monitors tire pressure, enhancing safety and performance.

Steps to Reset the Tire Pressure Sensor

1. Ensure that all tires are inflated to the recommended pressure.
2. Turn the ignition key to the “ON” position without starting the engine.
3. Locate the TPMS reset button, usually found under the steering column or near the dashboard.
4. Press and hold the TPMS reset button until the TPMS light blinks three times, then release it.
5. Start the engine and drive for a few minutes. The TPMS light should turn off if the reset is successful.

Tire Pressure Monitoring System Light Flashing

If the TPMS light continues to flash after following the reset procedure, it may indicate a malfunction in the system. Here are some common reasons:

What to Do If the Light Persists

If the TPMS light remains illuminated after resetting and checking tire pressures, consider these steps:

• Inspect each tire for visible damage or punctures.
• Check the tire pressure again to ensure accuracy.
• Consult a mechanic or your Yamaha dealer for diagnostic services.

Importance of Maintaining Proper Tire Pressure

Maintaining proper tire pressure is essential for the performance and safety of your Yamaha TTR 125. Incorrect tire pressure can lead to various issues, including poor handling, increased tire wear, and compromised safety. Riding with under-inflated tires can cause them to overheat, while over-inflated tires can lead to reduced traction and a harsher ride. Regularly checking and adjusting tire pressure is a simple yet crucial maintenance task.

How to Check Tire Pressure

Checking tire pressure is straightforward and can be done with a few tools. Follow these steps for accurate results:

1. Gather your tools: a reliable tire pressure gauge and an air compressor (if needed).
2. Ensure your tires are cold, as pressure readings can be affected by heat from riding.
3. Remove the valve cap from the tire you wish to check.
4. Press the tire pressure gauge onto the valve stem firmly to get a reading.
5. Note the reading and compare it to the recommended pressure listed in your owner’s manual.
6. If the pressure is too low, add air until it reaches the recommended level. If it’s too high, release some air.
7. Replace the valve cap securely after checking.

Useful Tips for Maintaining Tire Pressure

To ensure your tires remain in optimal condition, consider the following tips:

• Check tire pressure at least once a month and before long rides.
• Inspect tires for signs of wear or damage, such as cracks or bulges.
• Use a reliable digital or analog tire pressure gauge for accurate readings.
• Keep a portable air compressor on hand for quick adjustments when needed.
• Be mindful of temperature changes, as tire pressure can fluctuate with the weather.
• Rotate your tires regularly to promote even wear.
• Consider investing in a tire pressure monitoring system for real-time updates.

By prioritizing tire pressure maintenance, you enhance your riding experience and extend the life of your tires. Properly inflated tires contribute to better fuel efficiency, improved handling, and overall safety on the road or trail.